You can also check this list of our battery operated thermostats to find your model number. If the thermostat is battery operated and the batteries are accessed from the front of the thermostat, please check the area around the batteries. After removing the thermostat, flip it over and look for the model number, which is printed on the back of the case, starting with the group of letters mentioned above. behind any safety device, or into any area near moving parts or hot surfaces without. The micro DB-25M connector combines the Serial Interface with the Telco Alarm. serial number, located on the nameplate as shown in figure 1.1. is starting with 8G, 8H or 8J try nightly build 8 or later. device, which implements bi-directional buffering and hot swap support for. If your Dexcom G6 transmitter’s serial no. starting with 80 or 81) you can use the master. For G6 transmitters manufactured after fall/end of 2018 (i.e. For second and following transmitters see Extend transmitter life below. If it does not separate you will need to refer to your owners guide as to how it removes from the wall. Connect G6 transmitter for the first time¶. Grasp the thermostat with the fingers of your hand on the top and your thumb on the bottom and try pulling the thermostat directly off the wall plate. The date at the end of the month is automatically adjusted for months with fewer than 31 days, including corrections for leap year.The clock operates in either the 24-hour or 12-hour format with an active-low AM/PM indicator. Most modern thermostats separate from the wall plate by pulling the thermostat straight off the wall. The RTC maintains seconds, minutes, hours, day, date, month, and year information. If you do not have a product ID card, the fastest way to find the model number is by removing the thermostat from the wall-plate. The fastest way to see your thermostat model number is to look for it on your thermostat ID card.